Gale 401a restoration
Re: Gale 401a restoration
I've really enjoyed following this thread well done Terry
F5Pi Amp(Nelson Pass design), Airtight ATM-4, Ruark Accolades, Pink Triangle TT, Roksan Artimiz, Clearaudio Discovery, Tom Evans Microgroove Plus, Audiolab 6000 CDT, Fran DAC, Dalkey Audio Interconnects.
Gale 401a restoration
Cheers Derek. Claus was here for a good hour this afternoon and spent most of that time with a smile on his face. I sensed he liked what he heard! He might post his thoughts.Derek wrote:I've really enjoyed following this thread well done Terry
It was fascinating comparing the Croft 'Iosis' (a special edition V5 according to Glenn) with it's 35 watts of classic, tube warmth and rich musicality and the Musical Fidelity with it's seemingly endless urge and boundless energy and power. Given the load - down to 2 ohms, the Croft coped very well but seemed to be digging very deep at times. The MF on the other hand never broke sweat and romped home.
If they were cars, the Croft would be an old Jag, very lovely, smooth, with a roarty note. And good for 100mph. The Nu-Vista M3. Well the M3 tag is very fitting. 4 litre V8 with glorious engine note anybody?
Thanks again Claus and good luck with the sale.
System 1. LP12/Mose Hercules/Ittok LVII/ATOC9III, Dynavector P75 MkIII, Denon DCD-A100, iPad/AirPlay, Accuphase e303x, Gale gs401a.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
Re: Gale 401a restoration
Great afternoon in Terry's (with danish meatballs as an added bonus!) listening to his Gales. They sounded great with good imaging and real umpf in the low and lower mids. Great job by Terry! We hooked up the Sonus Fabers for a quick spin afterwards, and they were certainly a bit more refined but of course never reached as deep. Still a very nice setup with both speakers, that it would be very hard to get tired of.
Re: Gale 401a restoration
It sure can Adrian! This beauty arrived today. Accuphase e303x. 1985, mint condition inside and out. No wooden case but happier without as the turntable shelf frames it perfectly.Adrian wrote:That's ma Boy!!!!!!!!!!
You are really in the swing of things now!!
I love the look of the Accuphase, with de wooden surround and analogue power meters......however can it be obtain in good condition?
TT 1986. Amp 1985. Speakers circa 1978. Retro bliss!
I'm holding off on ordering the crossover parts for the Gales. The refoamed drivers are only now starting to show and I want to see where they take me before making any changes to the xo.



System 1. LP12/Mose Hercules/Ittok LVII/ATOC9III, Dynavector P75 MkIII, Denon DCD-A100, iPad/AirPlay, Accuphase e303x, Gale gs401a.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
Re: Gale 401a restoration
Great buy Terry! I must invite myself over whenever this beauty has settled in! Are your lovely pre/power combo staying?
Re: Gale 401a restoration
Always welcome Claus. And yes, I will be offering the Croft and Dynavector pre and phono stage for sale shortly.Claus wrote:I must invite myself over whenever this beauty has settled in! Are your lovely pre/power combo staying?
System 1. LP12/Mose Hercules/Ittok LVII/ATOC9III, Dynavector P75 MkIII, Denon DCD-A100, iPad/AirPlay, Accuphase e303x, Gale gs401a.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
Re: Gale 401a restoration
Loving these Gales! Interesting article with classic pic here...
http://zstereo.co.uk/2014/01/19/gale-gs401a/
Best.
Terry
http://zstereo.co.uk/2014/01/19/gale-gs401a/
Best.
Terry
System 1. LP12/Mose Hercules/Ittok LVII/ATOC9III, Dynavector P75 MkIII, Denon DCD-A100, iPad/AirPlay, Accuphase e303x, Gale gs401a.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
Re: Gale 401a restoration
Enjoying the long evenings.

System 1. LP12/Mose Hercules/Ittok LVII/ATOC9III, Dynavector P75 MkIII, Denon DCD-A100, iPad/AirPlay, Accuphase e303x, Gale gs401a.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
Re: Gale 401a restoration
Nice little project here for somebody. Very rare with original stands. MK I's - just one fuse.
http://www.ebay.ie/itm/111847530113?_tr ... EBIDX%3AIT
http://www.ebay.ie/itm/111847530113?_tr ... EBIDX%3AIT
System 1. LP12/Mose Hercules/Ittok LVII/ATOC9III, Dynavector P75 MkIII, Denon DCD-A100, iPad/AirPlay, Accuphase e303x, Gale gs401a.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
System2. iMac/Tidal, iFI Dac, Dynavector L200 pre, Croft Iosis, Sonus Faber Auditor M.
Re: Gale 401a restoration
HI
Yes, they are for me.
For a french Gale GS401A owners.
I have already one pair, but I think that they are the first one. One fuse too
The crossover is black and the number are 000259 and 000300 on an iron plate.
I never seen that before.
Do you have an idea ?
Yes, they are for me.
For a french Gale GS401A owners.
I have already one pair, but I think that they are the first one. One fuse too
The crossover is black and the number are 000259 and 000300 on an iron plate.
I never seen that before.
Do you have an idea ?
- Attachments
-
- DSC05407.JPG (60.09 KiB) Viewed 978 times
-
- DSC05406.JPG (72.8 KiB) Viewed 978 times