Re: It didn't explode....... YET (aka niges amp)
Posted: Tue Oct 31, 2017 11:08 pm
- FB_IMG_1509487635427.jpg (16.51 KiB) Viewed 1049 times
Tír Na HiFi
Hi-End HiFi in Ireland
https://tirnahifi.org/forum/
It didn't explode....... YET (aka niges amp)
Page 57 of 76
Re: It didn't explode....... YET (aka niges amp)
Posted: Tue Oct 31, 2017 11:23 pm
You can do fine pitch SM chips without magnification? I need proof lol
I can barely do them with magnification.
Re: It didn't explode....... YET (aka niges amp)
Posted: Wed Nov 01, 2017 12:14 am
I can do 603 without magnification - no problem. I did a couple of 402 but with a good daylight. I guess positioning them is the tough part. Once you hold them properly in place it gets easier. Also, BGA balls can be used to take just enough of solder on your soldering tip.
F
F
Re: It didn't explode....... YET (aka niges amp)
Posted: Thu Nov 02, 2017 9:49 pm
Ok amp assembly starts Saturday if enough amp crew are available
Re: It didn't explode....... YET (aka niges amp)
Posted: Sat Nov 04, 2017 10:10 pm
another day of madness............
we got batteries installed in 5 cases
and got transformers heatsinks and psu units in two of them
and almost the same in a third
these psus where tested and set to the appropriate voltage
Re: It didn't explode....... YET (aka niges amp)
Posted: Sun Nov 05, 2017 10:59 pm
Great work guys.....
Re: It didn't explode....... YET (aka niges amp)
Posted: Mon Nov 06, 2017 12:23 am
Very impressive!
I miss "piece of the action"! :)
I miss "piece of the action"! :)
Re: It didn't explode....... YET (aka niges amp)
Posted: Sun Nov 12, 2017 3:40 pm
Another 2 good weekends work and finally taking shape.
We have 3 amps close to finish now so hopefully another couple of get together s will finish these and bring the remaining amps to to finish line.
Some pics below.
We have 3 amps close to finish now so hopefully another couple of get together s will finish these and bring the remaining amps to to finish line.
Some pics below.
Re: It didn't explode....... YET (aka niges amp)
Posted: Sun Nov 12, 2017 4:15 pm
Well done, I would have loved to have done this, maybe next time if you aren't put off! Those amps look the biz.
Re: It didn't explode....... YET (aka niges amp)
Posted: Sun Nov 12, 2017 7:12 pm
lol.. next time
we were joking before about calling it the "never again" amp
it really turned out to be quite a lot of work to get the quality and cosmetics we way we wanted
the case work seems to be far more time consuming than the electronics
hopefully all involved will we happy with their amps when there all finished
and be able to sit back and say we built it and it sounds great
we were joking before about calling it the "never again" amp
it really turned out to be quite a lot of work to get the quality and cosmetics we way we wanted
the case work seems to be far more time consuming than the electronics
hopefully all involved will we happy with their amps when there all finished
and be able to sit back and say we built it and it sounds great