Filthy, Mouldy Cd`s!

bod
Posts: 299
Joined: Sun Feb 14, 2010 9:52 pm

Filthy, Mouldy Cd`s!

Post by bod »

Hi Folks. No, this is not a rant on the hateful silver disc! My problem is as follows:
I stored hundreds of cd`s in three of the Argos 256 cd wallet jobbies a few years ago. Initially it was only meant to be for a couple of months but I ended up leaving them there. Now I`m left with discs which have a tough, hard mould caked onto them at the bit of the wallet that the plastic doesn`t cover (if you follow me). I`ve tried soft cloths etc. to try and remove the mould but no luck. I`m quite wary of the JML type cleaners as they would probably do more harm than good. Any suggestions on a safe, cheap way of cleaning them?
Cheers. Dave.
User avatar
Fran
Site Admin
Posts: 4141
Joined: Sat Jan 16, 2010 10:03 pm

Re: Filthy, Mouldy Cd`s!

Post by Fran »

Toothpaste?
Do or do not, there is no try
User avatar
Ivor
Posts: 4229
Joined: Sat Jan 16, 2010 11:21 pm

Re: Filthy, Mouldy Cd`s!

Post by Ivor »

Fran wrote:Toothpaste?
If used gently. Also only rub any cleaning agent from the centre to middle - as opposed to how you'd clean vinyl.
Vinyl -anything else is data storage.

Thorens TD124 Mk1 + Kuzma Stogi 12"arm, HANA Red, Gold Note PH 10 + PSU. ADI-2 Dac, Lector CDP7, Wyred4Sound pre, Airtight ATM1s, Klipsch Heresy IV, Misc Mains, RCA + XLR ICs, Tellurium Q spkr cable
User avatar
Fran
Site Admin
Posts: 4141
Joined: Sat Jan 16, 2010 10:03 pm

Re: Filthy, Mouldy Cd`s!

Post by Fran »

Theres a chrome polish for cars called autoglym - you'll find it in any motor factors. That might be good too and will leave a mirror finish:


Image

Probably a really good clean followed by something like that should do the trick. Do it with your least valuable one and see how it goes...

Fran
Do or do not, there is no try
User avatar
Ivor
Posts: 4229
Joined: Sat Jan 16, 2010 11:21 pm

Re: Filthy, Mouldy Cd`s!

Post by Ivor »

Fran wrote: Do it with your least valuable one and see how it goes...
Aye... start with the Chris Rea disks and then.....
Vinyl -anything else is data storage.

Thorens TD124 Mk1 + Kuzma Stogi 12"arm, HANA Red, Gold Note PH 10 + PSU. ADI-2 Dac, Lector CDP7, Wyred4Sound pre, Airtight ATM1s, Klipsch Heresy IV, Misc Mains, RCA + XLR ICs, Tellurium Q spkr cable
User avatar
Gerry D
Posts: 1076
Joined: Sun Feb 07, 2010 3:25 pm
Location: Dublin

Re: Filthy, Mouldy Cd`s!

Post by Gerry D »

If used gently. Also only rub any cleaning agent from the centre to middle - as opposed to how you'd clean vinyl.

Sure it isn't from the middle to the centre ?
"Quality means doing it right when no one is looking" - Henry Ford
DancingPriest
Posts: 138
Joined: Mon Mar 01, 2010 4:52 pm

Re: Filthy, Mouldy Cd`s!

Post by DancingPriest »

Gerry D wrote:Sure it isn't from the middle to the centre ?
middle=centre, no?
Centre to edge?
Living Room: Naim Muso 2

Listening Room: TBC, I'm new to this.

Shed: Chromecast Audio, Onkyo 9010, Wharfedale 220, Roth Audio Sub (8" ported cheapy)
User avatar
Ivor
Posts: 4229
Joined: Sat Jan 16, 2010 11:21 pm

Re: Filthy, Mouldy Cd`s!

Post by Ivor »

DancingPriest wrote:
Gerry D wrote:Sure it isn't from the middle to the centre ?
middle=centre, no?
Centre to edge?
yes of course... middle to the outer edge.
The same is true even if you're getting a fingerprint or smudge off a DVD/CD
Vinyl -anything else is data storage.

Thorens TD124 Mk1 + Kuzma Stogi 12"arm, HANA Red, Gold Note PH 10 + PSU. ADI-2 Dac, Lector CDP7, Wyred4Sound pre, Airtight ATM1s, Klipsch Heresy IV, Misc Mains, RCA + XLR ICs, Tellurium Q spkr cable
DancingPriest
Posts: 138
Joined: Mon Mar 01, 2010 4:52 pm

Re: Filthy, Mouldy Cd`s!

Post by DancingPriest »

Otherwise T-cut has done the job for me when resurecting a few CD roms. It's also very important to follow Ivors advice, never polish in a circular motion.
Living Room: Naim Muso 2

Listening Room: TBC, I'm new to this.

Shed: Chromecast Audio, Onkyo 9010, Wharfedale 220, Roth Audio Sub (8" ported cheapy)
bod
Posts: 299
Joined: Sun Feb 14, 2010 9:52 pm

Re: Filthy, Mouldy Cd`s!

Post by bod »

Thanks a mill for all the replies folks. Much appreciated. Cheers. Dave
Post Reply