Bowers & Wilkins B & W DM220 Speakers-customised white gloss
Posted: Wed Jun 24, 2015 3:31 pm
Bowers & Wilkins B & W DM220 Speakers - customised stands and white gloss paint finish
***Note: I have now done some more upgrading to these speakers. I have lined the cabinets internally with vehicle anti vibration sheets, and then lined the cabinets throughout with 1 and a half inch furniture foam. This has made a significant improvement to the sound / performance. In particular, the bass is much tighter and assured, and a little lower. I spent 2 days working on them, and 80 euro on materials. foam & self adhesive anti vibration mats. So these now cost 600 euro.****
Specifications
Drive Units:
1 x 26mm dome/coil construction of special polymide material
2 x 200mm nominal piston dia and 26mm high temperature voice coil with critically impregnated composite short fibre cone
Frequency Response: ± 3dB 53Hz to 20kHz
Sensitivity: 90dB (2.83V, 1m
Power Handling: 10W – 100W
Dimensions (H x W x D): 680 x 290 x 320 mm
***Note: I have now done some more upgrading to these speakers. I have lined the cabinets internally with vehicle anti vibration sheets, and then lined the cabinets throughout with 1 and a half inch furniture foam. This has made a significant improvement to the sound / performance. In particular, the bass is much tighter and assured, and a little lower. I spent 2 days working on them, and 80 euro on materials. foam & self adhesive anti vibration mats. So these now cost 600 euro.****
Specifications
Drive Units:
1 x 26mm dome/coil construction of special polymide material
2 x 200mm nominal piston dia and 26mm high temperature voice coil with critically impregnated composite short fibre cone
Frequency Response: ± 3dB 53Hz to 20kHz
Sensitivity: 90dB (2.83V, 1m
Power Handling: 10W – 100W
Dimensions (H x W x D): 680 x 290 x 320 mm