Tír Na HiFi

jkeny wrote:You bought some bybees?
Have you taken them apart yet? :)

Quite a while back im not sure i could locate :)

Do do know they have the tamperproof seal of been expensive

Is there pics online?

nige2000 wrote:

jkeny wrote:You bought some bybees?
Have you taken them apart yet? :)

Quite a while back im not sure i could locate :)

Do do know they have the tamperproof seal of been expensive

Yea, I heard you need special treatment to get through that barrier - psychological counselling, I believe it's called :)

Is there pics online?

I think there are but they may be the Bybees for PS lines?

@val33 any luck?

jkeny wrote:

nige2000 wrote:

jkeny wrote:You bought some bybees?
Have you taken them apart yet? :)

Quite a while back im not sure i could locate :)

Do do know they have the tamperproof seal of been expensive

Yea, I heard you need special treatment to get through that barrier - psychological counselling, I believe it's called :)

Is there pics online?

I think there are but they may be the Bybees for PS lines?

if i find the bybee ill shall find my knife:)

I have not come across Bybees, but looking at this page describing their technology -

http://bybeetech.com/?page_id=11

I found that my belief in physics had been suspended. I think I will need psychological counselling. Goodness knows what force fields will be surrounding nige, if he does take his knife to one!

Please put me right, if you two think this is real science.

Well it changes the sound
as does lots of things

nige2000 wrote:@val33 any luck?

Yes and no, mostly no.

I eventually found a minute stray ball of solder caught in the legs of U39. Removing this has got uManager working again. I have reloaded the software and have full communication with the DAM, but still no output. I get flashing LED on startup and it goes solid once the i2s signal is on.

I've removed the mute relays.

Really not sure what else to try, other than perhaps replace U39, whatever it is, anyone?

Val

Just worked out that U39 is the RS232 transmitter, so probably not the cause of my issue and no doubt working correctly as I am able to communicate with uManager.

Val

still stumped here too
U39 is the serial interface chip

If u reloaded the firmware with it its likely ok

Vref voltages ok?