Tír Na HiFi

tony came down today and we got a good nudge on with the case work, we cut drilled and tapped most of the alminium fittings, we also drilled and tapped the case bottom panel, we can start assembling battery packs on them the next day



tony might have better pics

Have some better photos but need to save them at a lower resolution to upload. Slow work but Nigel seemed happy with the progress. Sliding mitre saw for cutting the alu was great. The days work ended up yielding a small pile of aluminium bits and lots of holes. Hopefully they will all fit ok when the time comes. We did try to be very careful.

Email me the photos I'll stick em up

I see one mistake today will be easy rectified though
Switch and vol pot mounting plate should be on the inside of the aluminium angle not the outside

Great work guys, that looks like fantastic progress! Hope we can add to that with the soldering this afternoon

Great stuff lads nice to see little piles of progress

More progress with the soldering too!

Pretty much all the assembly is done on the boards bar a few transistors (that I seem to have misordered) and the 47uf cap for the turn off delay.

We also made a start on the transformer wiring - there's a bit of figuring out to be done there.

tony wrote: ↑Fri Jul 07, 2017 11:17 pm Have some better photos but need to save them at a lower resolution to upload. ......

Pixresizer is your friend.... http://bluefive.pairsite.com/pixresizer.htm

Excellent work guys