![Image](https://farm4.staticflickr.com/3933/32509964543_1a6c5b1496.jpg)
Cool stuff
Very sturdy
Getting the lend of a chop saw with those fancy blades that cuts anything from butter to steel
So that should make things easier
I dropped the stl file for the bottom case part into the quote engine and it came up with a message that the part was too big.nige2000 wrote: ↑Tue Mar 07, 2017 11:39 pm dunno if these guys an be taken seriously
http://www.3dprintingpoint.ie/
whaa....Sligolad wrote: ↑Wed Mar 08, 2017 8:28 pmI dropped the stl file for the bottom case part into the quote engine and it came up with a message that the part was too big.nige2000 wrote: ↑Tue Mar 07, 2017 11:39 pm dunno if these guys an be taken seriously
http://www.3dprintingpoint.ie/
I dropped in a smaller file for doing all the rods at about 125 grammes and it came up with a quote for €800 plus for one piece using basic printing.
When i selected the SLA option it jumped up to almost 2k.
They appear to be the genuine article with the options they offer but expensive.
just gettin a proper look at these binding posts, i think i like em
yea im sure it would be interesting to watch the facial expressions of on lookers at Scalford,tony wrote: ↑Wed Mar 08, 2017 11:20 pm It is all looking really brilliant Nigel. You better take a note of the production process you might end up making another batch if the photo's so far are anything to go by. Seem another trip to Scalford to show our friends across the water how to do it right might be in order.
yes well worth it