Lossless SD digital Player is computer audio now reborn?

[wushuliu]

pics please
Are u using a 574 or the potato 7474

Mucking about with i2s gnding might get 192 working
Lifepo4?

I was using 574. lifepo4 charged and will be next mod. I'll get pics up in a bit.

[wushuliu]

does it matter if I use the lifepo while attaches to charging power? adding a on off switch will be hopeless as i'm sure to forget to use it and drain the batteries

[nige2000]

does it matter if I use the lifepo while attaches to charging power? adding a on off switch will be hopeless as i'm sure to forget to use it and drain the batteries

Were all the forgetful same here too
We charge linear into cells continiously
I cant hear any neg effects
But using a switch mode might let a little noise through

Pics tell a thousand words
Might have more ideas to fix reclock then

[wushuliu]

Pics

[wushuliu]

574. I feel like I missed something but not sure where.

[nige2000]

574. I feel like I missed something but not sure where.

Gnd on pin one please for enable

[nige2000]

Need to get a 32.768khz clock to replace that crystal
Its the most benificial one and very important

Also these clocks should have a vcc from lifepo4 cell wired direct to minamise noise
I mounted the clocks vertical to do that

Any chance of shorting the i2s more?

[wushuliu]

Need to get a 32.768khz clock to replace that crystal
Its the most benificial one and very important

Also these clocks should have a vcc from lifepo4 cell wired direct to minamise noise
I mounted the clocks vertical to do that

Any chance of shorting the i2s more?

? I replaced the 32.768khz already. Is there another kind I should be using? (as you can tell the digital stuff is way over my head).

Ah, will do on the pin 1 574.

EDIT: okay, I see clock vs. crystal. I thought they meant the same thing...

[wushuliu]

getting caught up on the clocks vs. crystal. But where did you get this green pad for your clock nige?

[nige2000]

getting caught up on the clocks vs. crystal. But where did you get this green pad for your clock nige?

The green boards are xo adapter boards from Ian's fifo reclock GB on diya
This clock just so happened to be on one of them from another project
And I just dropped it in
Usually solder them on direct now

https://www.digikey.ie/product-detail/e ... ND/3719808

Is what I used