HELP

Adrian
Posts: 830
Joined: Tue Jan 26, 2010 9:47 am

Re: HELP

Post by Adrian »

The Cloney boys to the rescue again!!!!!!!!!!!!!

Yeeeeeeeeeeeeee Haaaaaaaaaaaaaaaaaaa.

But its good to have the back up!!!!!!!!!!
Let the Good Times Roll...................
Dowser
Posts: 153
Joined: Mon Jan 18, 2010 12:05 pm

Re: HELP

Post by Dowser »

If you need to keep same length I would just repair at the cut - put some suitably sized heatshrink over one of the cut pieces - strip back the insulator a cm or so on each side and tin with solder, solder a wire link across the break points. Heatshrink over the top and you'll have a passable repair.

Richard
Manc Pat
Posts: 18
Joined: Mon Jun 21, 2010 9:17 pm

Re: HELP

Post by Manc Pat »

Am I right hooking up my interconnects in the direction of the arrow into the amp??
Manc Pat
Posts: 18
Joined: Mon Jun 21, 2010 9:17 pm

Re: HELP

Post by Manc Pat »

Hope that makes sense!!!!!!
User avatar
Ivor
Posts: 4228
Joined: Sat Jan 16, 2010 11:21 pm

Re: HELP

Post by Ivor »

Manc Pat wrote:Am I right hooking up my interconnects in the direction of the arrow into the amp??
Yep. The signal is going from the source, be it CD player, tuntable tuner or whatever and travels to the amp - in the direction of the arrow. From personal expierience I would always use an interconnect in the one direction once it's "burnt in".
Vinyl -anything else is data storage.

Thorens TD124 Mk1 + Kuzma Stogi 12"arm, HANA Red, Gold Note PH 10 + PSU. ADI-2 Dac, Lector CDP7, Wyred4Sound pre, Airtight ATM1s, Klipsch Heresy IV, Misc Mains, RCA + XLR ICs, Tellurium Q spkr cable
Manc Pat
Posts: 18
Joined: Mon Jun 21, 2010 9:17 pm

Re: HELP

Post by Manc Pat »

Thanks Ivor.
Post Reply